There are two basic Finger Protector® hinge cavity products for:
Standard Doors (HC)
Conventional doors with standard butt, rising butt or pivot hinges,
including glass.
Non Standard Doors (HC-N)
All other non standard door and frame types including PVCu,
Crittall, steel, glass, aluminium, non-standard pivot hinge, bi-folding
doors etc.
Check the door size
Most doors can be protected with a single Finger Protector® Hinge
Cavity (HC) shield section, however the unique (patent) piggy-back
design allows the shield section to be extended safely to fit any
door size.
Read more..
Dorgard™ allows you to legally hold open fire doors via a wireless automatic door release system attached
to the door that releases the door when the fire alarm is sounded.
Read more..
The Hinge Pin side (HP) Finger Protector® is supplied in one size to fit
all hinged doors – except large parliament hinges etc. These however
can be shielded, call for advice.
Read more..
The safest device available to protect fingers from a slamming door
whilst allowing the door to fully close. Alternative products that block
full door closure are a hazard in the event of a fi re. The Slam Stopper™
Handle Side (HS) system is supplied in one size to fi t nursery/domestic
doors and doors not using a door closer.
Read more..
Slide Safe™ has been designed primarily for external two-panel
in-line sliding door systems, either left-hand or right-hand opening.
Slide Safe™ is not intended for use with ‘tilt and slide’ or ‘lift and
slide’ door systems.
For aluminium sliding door systems doors use ‘SP45’. For PVCu
or Timber sliding door systems measure the overall width of the
frame and specify ‘SP50’ for door frames 73-110mm wide and
‘SP55’ for frames 120-150mm wide.
Read more..
Get in Touch
If you have any queries or would like further information,
please email
DoorFingerProtector
call us on
+44 (0) 8700601719
or fax us on
+44 (0) 8700601718